Poulan Pro 193747 Operator's Manual page 10

ASSEMBLE UPSTOP
BRACKET
(SEE ILLUSTRATION ABOVE)
• Position upstop bracket over hole inside
the left side of upper handle and install
upstop bracket screw #10-24 x 1/2.
Tighten securely.
ASSEMBLE WHEELS
(USE HARDWARE GROUP "C")
NOTE: Some model mowers do not have
baffl es on underside of mower housing.
On models without baffl e in front and/or
rear of housing, use the 1-1/4" washers
sup plied when you assemble the wheels.
MODELS WITH BOLT-ON WHEELS:
Cutting height is de ter mined by as sem -
bling wheels in one of four possible posi-
tions on the mower housing. All wheels
must be in the same height position for
even cut ting.
• For each wheel, assemble shoul der bolt,
wheel and spacer as shown.
• Assemble 1-1/4" diam. washer (if sup-
plied) and 3/8-16 lock nut on inside of
mower housing and tight en se cure ly.
1-1/4" diameter Washer
(Rear wheels only)
Mower housing
Spacer
Shoulder
bolt
Wheel
(SIDE DISCHARGE MOWER SHOWN)
MODELS WITH "QUICK ADJUST"
WHEEL HEIGHT ADJUSTERS :
Look carefully at the four (4) adjuster
assemblies. Notice that there are two (2)
each of two (2) different types.
Type I is for the
Right Rear and Left
Front installation.
3/8-16
Locknut
Type II is for the
Right Front and Left
Rear installation.
10
ASSEMBLE ADJUSTERS TO DECK
• Position appropriate adjuster at each
corner of mower.
• Install each adjuster with adjuster bolt
and tab in deck holes as shown and
secure with 1-1/4" diam. washer (if sup-
plied) and 3/8-16 locknut. Tight en all
adjusters se cure ly.
SIDE DISCHARGE MOWERS:
Tab hole
TYPE I
Right rear/left front
height ad just er
TYPE II
Right front/left rear height ad just er
REAR DISCHARGE MOWERS:
Tab hole
TYPE I
Right rear/left front
height ad just er
TYPE II
Right front/left rear height ad just er
ASSEMBLE WHEELS TO ADJUSTERS
• Secure each wheel with fl at washer
and retainer spring or fl ange locknut (if
equipped with threaded axle).
• Assemble adjustment knobs to ad just er
levers by press ing or tapping lightly.
• If your mower is equipped with hub caps,
install by pressing or tap ping lightly until
hub cap snaps se cure ly over fl at wash er.
Axle arm
Wheel
Flat washer
Retainer
spring
Hubcap (If epuipped)
1-1/4" Washer
(If supplied)
Locknuts
Tab hole
1-1/4" Washer
(If supplied)
Locknuts
Tab hole
Adjustment
knob
Flange locknut
(If equipped with
threaded axle arm)