Battery - Uniden Guardian App Cam Solo Owner's Manual

Install the SD Card
1. Power off the camera by taking out the batteries before inserting the SD
card.
2. Insert the SD card in the SD card slot on the right side of the camera. Use
your fingernail (or use the provided reset needle) to push the SD card in
until you feel it is locked.
Format the SD Card
Tap the Format icon on the bottom to format the SD card.
Note : Please backup the important data on the SD card before formatting it.

Battery

Uniden provides 4 non-rechargeable CR123A batteries, one of which has
1600mAH.
With these 4 batteries, the Argus supports up to:
180 days in Standby mode;
•
840 minutes of motion recording and Live view in day time;
•
420 minutes of motion recording and Live view in night vision with IR LED's
•
on.
Note: App Cam Solo is not designed for 24/7 full capacity running or round-
the-clock live streaming. It's designed to record motion events and remotely
view live streaming only when you need it. Long time live view or frequently
PIR triggering will drain the batteries more quickly.
Requirement of the Battery
The App Cam Solo camera will work with the following batteries:
Battery
Non-rechargeable
Rechargeable
Battery Status
The camera will keep a record of the power consumption for the last 4 weeks,
to check the battery status, tap on the camera in Devices , or go to " Device
Settings " > " Battery ".
Type
CR123A
CR123A
Voltage
3V
3.6V~4.2V
35