NAD C 558 Owner's Manual
  1. Manuals
  2. Brands
  3. NAD Manuals
  4. Turntable
  5. C 558
  6. Owner's manual

NAD C 558 Owner's Manual

Hide thumbs Also See for C 558:
Table of Contents

Advertisement

Quick Links

See also: Owner's Manual
C 558
®
Turntable
Owner's Manual

Advertisement

Table of Contents
loading

Related Manuals for NAD C 558

Summary of Contents for NAD C 558

  • Page 1 C 558 ® Turntable Owner’s Manual...

  • Page 2: Important Safety Instructions

    (servicing) instructions in the literature accompanying the appliance. For your convenience, record the model number and serial number in the space provided ark of NAD Electronics International, a division of Lenbrook Industries Limited below. Please refer to them when you contact your dealer in case of difficulty.

  • Page 3: Getting Started

    White cotton gloves SAVE THE PACKAGING Please save the box and all of the packaging in which your C 558 arrived. Should you move or need to transport your C 558, this is the safest container in which to do so. We’ve seen too many otherwise perfect...

  • Page 4: Identification Of Controls

    IDENTIFICATION OF CONTROLS 1 Platter 8 Dustcover 15 Anti-Skating Adjustment 2 Felt Mat 9 Dustcover Hinges 16 Headshell With Finger Lift 3 Sub-Platter 10 Hinge Fasteners 17 Damped Feet 4 Motor Pulley 11 Counterweight 18 RCA Output, Earth Connection 5 Drive Belt 12 Tonearm 19 Power Supply Socket 6 Plinth...

  • Page 5: Installation

    SETUP PLATTER, SUB-PLATTER, FELT MAT AND DRIVE BELT VERTICAL TRACKING FORCE SETTING (VTF) INSTALLATION 1 Confirm the exact weight of your cartridge before setting the Vertical 1 Install sub-platter (3) and drive belt (5). Tracking Force (VTF). 2 Push the counterweight carefully towards the rear end of the counterweight support rod.

  • Page 6: Vertical Tracking Angle Setting (Vta)

    SETUP VERTICAL TRACKING ANGLE SETTING (VTA) ANTI-SKATING FORCE ADJUSTMENT 1 Set the Vertical Tracking Angle (VTA) by putting a record on the platter. The anti-skating force must be adjusted to the corresponding tracking 2 When the needle is lowered into the record groove, the tube of the force.

  • Page 7: Troubleshooting

    TROUBLESHOOTING PROBLEM POSSIBLE CAUSE • The unit is not connected to the mains power supply. The platter doesn’t turn although the unit is switched on. • No mains power is being delivered at the socket. • The drive belt is not fitted properly or has slipped off. •...

  • Page 8: General Specifications

    435 x 340 x 125mm 17 1/8 x 13 7/16 x 4 15/16 inches Shipping weight 8 kg (17.6 lbs) Specifications are subject to change without notice. For updated documentation and features, please check out www.NADelectronics.com for the latest information about C 558.
  • Page 10 All rights reserved. NAD and the NAD logo are trademarks of NAD Electronics International, a division of Lenbrook Industries Limited. No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International.

Table of Contents