Table of Contents
Advertisement
INSTALL SEAT (See Fig. 3)
Adjust seat before tightening adjustment knob.
•
Remove adjustment knob and flat washer securing seat
to cardboard packing and set aside for assembly of seat
to tractor.
•
Pivot seat upward and remove from the cardboard
packing. Remove the cardboard packing and discard.
•
Place seat on seat pan so head of shoulder bolt is
positioned over large slotted hole in pan.
•
Push down on seat to engage shoulder bolt in slot and
pull seat towards rear of tractor.
•
Pivot seat and pan forward and assemble adjustment
knob and flat washer loosely. Do not tighten.
•
Lower seat into operating position and sit on seat.
•
Slide seat until a comfortable position is reached which
allows you to press clutch/brake pedal all the way down.
•
Get off seat without moving its adjusted position.
•
Raise seat and tighten adjustment knob securely.
SEAT PAN
FLAT WASHER
ADJUSTMENT
KNOB
NOTE: You may now roll or drive your tractor off the skid.
Follow the appropriate instruction below to remove the
tractor from the skid.
ASSEMBLY
SEAT
SHOULDER
BOLT
FIG. 3
TO ROLL TRACTOR OFF SKID (See Operation
section, page 12, for location and function of
+
controls)
REMOVE THE FOLLOWING BULLET FOR MODELS
WITH ELECTRIC LIFT.
•
Press lift lever plunger and raise attachment lift lever to
its highest position.
•
Release parking brake by depressing clutch/brake pedal.
•
Place gearshift lever in neutral (N) position.
+
•
Roll tractor forward off skid.
ADD THE FOLLOWING BULLET FOR MODELS WITH
MOWER DECK ATTACHED.
•
Remove banding holding deflector shield up against
tractor.
TO DRIVE TRACTOR OFF SKID (See Opera-
tion section, page 12, for location and func-
tion of controls)
WARNING: Before starting, read, understand and
follow all instructions in the Operation section of this manual.
Be sure tractor is in a well-ventilated area. Be sure the area
in front of tractor is clear of other people and objects.
•
Be sure all the above assembly steps have been
completed.
•
Check engine oil level and fill fuel tank with gasoline.
•
Sit on seat in operating position, depress clutch/brake
pedal and set the parking brake.
•
Place gear shift lever in neutral (N) position.
•
Press lift lever plunger and raise attachment lift lever to
its highest position.
•
Start the engine. After engine has started, move throttle
control to idle position.
•
Depress clutch/brake pedal into full "BRAKE" position
and hold. Move gearshift lever to 1st gear.
•
Slowly release clutch/brake pedal and slowly drive
tractor off skid.
•
Apply brake to stop tractor, set parking brake and place
gearshift lever in neutral position.
•
Turn ignition key to "OFF" position.
Continue with the instructions that follow.
ASSEMBLE GAUGE WHEELS TO MOWER
DECK (See Fig. 4)
The gauge wheels are designed to keep the mower deck in
proper position when operating mower. Be sure they are
properly adjusted to ensure optimum mower performance.
•
Slide gauge wheel bar down into bracket channel, Be
sure that gauge wheel bar aligning holes are on top.
Assemble gauge wheels as shown using shoulder bolts,
3/8 washers and 3/8-16 center locknuts and tighten
securely.
•
For ease of mower to tractor assembly, raise gauge
wheels to highest position and retain with clevis pins and
spring retainers.
•
Adjust gauge wheels before operating mower. See "TO
ADJUST GAUGE WHEELS" in the Operation section of
this manual.
7
Advertisement
Table of Contents
