Miele TCE 630 WP Operating Instructions Manual page 47

Problem
 lights up
Bars flash in the display
at the end of a
programme:
.........
 flashes/lights up
after the tumble dryer is
switched on and a
programme cannot be
selected
 and  light up after
a programme has been
cancelled, a signal
sounds
 and another number
combination flash after
a programme has been
cancelled, a signal
sounds
: lights up and the
programme has been
cancelled, a signal
sounds
Possible cause and remedy
The programme selector has been moved.
 Select the original programme. The time remaining
will appear in the display again.
The programme has finished but the laundry has not
yet cooled down.
 Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.
Access via a code has been activated.
 See "Programmable functions -  Code".
An excessive amount of fluff has built up.
 Clean the fluff filters.
 Clean the plinth filter.
 Clean the airways: the area underneath the plinth
filter and the heat exchanger.
 See "Cleaning and care".
To switch off  :
 Switch the dryer off and then on again.
There is no obvious cause.
 Switch the dryer off and then on again.
 Start a programme.
If the programme terminates again with the same
error message, then there is a fault. Contact Miele.
The laundry is unevenly distributed or has rolled up.
 Disentangle the laundry and remove a few items, if
necessary.
 Switch the dryer off and then on again.
 Start a programme.
Problem solving guide
47