Table of Contents
Advertisement
1
S E T T I N G U P
The installation process prompts you
•
to connect your Centro 690 to your
computer. Go to the next section.
Connecting your Centro 690 to your
computer
After you install the desktop software (see
Installing the desktop synchronization
software), you're ready to connect your
Centro 690 to your computer.
BEFORE YOU BEGIN
computer, you need the sync cable that
came with your Centro 690.
1 Plug the AC charger into a wall outlet.
2 Plug the USB sync cable into an
available USB port or into a powered
USB hub connected to your computer.
For best performance, plug your sync
TIP
cable directly into a USB port on your
computer. If your computer has USB ports on
both the front and back, we recommend using
the back port; the front port is often a
low-power port. If you use a USB hub, make
sure the hub has its own power supply.
22
S E T T I N G U P Y O U R C O M P U T E R F O R S Y N C H R O N I Z A T I O N
To set up your
3 With the sync button facing up, connect
the sync cable to the bottom of your
Centro 690. Do not press the sync
button until you are instructed to do so.
4 (Optional) Connect the charger cable to
the bottom of your Centro 690.
You are now ready to synchronize; go to
Synchronizing information—the basics.
Sync cable
Sync button
Advertisement
Table of Contents
