Reboot/Reset To Factory Defaults - TRENDnet TPE-TG44ES User Manual

TRENDnet User's Guide

Reboot/Reset to factory defaults

Tools > Reboot
This section provides the procedures for rebooting or resetting the switch to factory
default settings.
To reboot your switch:
You may want to reboot your switch if you are encountering difficulties with your switch
and have attempted all other troubleshooting.
There are two methods that can be used to reboot your switch.

Hardware Method: Push the power on/off switch to the off (o) position then to
the on position (|) or disconnect the power adapter and reconnect.

Software Method (Switch Management Page):
1. Log into your switch management page (see
on page 6).
2. Click on Management.
3. Under the section Reset to Default / Reboot, click the Reboot. When prompted to
Reboot System, click OK. Wait for the switch complete the rebooting process.
© Copyright 2017 TRENDnet. All Rights Reserved.
"Access your switch management page"
To reset your switch to factory defaults:
You may want to reset your switch to factory defaults if you are encountering difficulties
with your switch and have attempted all other troubleshooting. Before you reset your
switch to defaults, if possible, you should backup your switch configuration first, see
"Backup and restore your switch configuration
There are two methods that can be used to reset your switch to factory defaults.

Hardware Method: Using a paper clip, on the front panel of the switch, push
and hold the Reset button more than 10 seconds and release. Located on the
front panel of your switch, see
this method if you are encountering difficulties with accessing your switch
management page.

Software Method (Switch Management Page):
1. Log into your switch management page (see
on page 6).
2. Click on Management.
3. Under the section Reset to Default / Reboot, click the Reboot. When prompted to
Reset System, click OK. Wait for the switch complete resetting the switch to factory
default settings.
The switch factory default settings are below.
Administrator User Name
Administrator Password
Switch IP Address
Switch Subnet Mask
TPE-TG44ES
settings" on page 77.
"Product Hardware Features" on page 2. Use
"Access your switch management
admin
admin
192.168.10.200
255.255.255.0
page"
19