Siemens KI**N series Instructions For Use Manual page 20

en
Fault
Appliance has no
refrigeration capacity.
The light does not work.
The display does not
illuminate.
Appliance is not cooling,
temperature display and light
are lit.
The light does not function.
Temperature display for
the refrigerator
compartment flashes.
Fig. "/7
Warning signal sounds and
the temperature display
flashes.
The freezer compartment
is too warm! Frozen food is at
risk.
20
Possible cause
Appliance has been switched
off.
Power failure.
The fuse has been switched
off.
The mains plug has not been
inserted properly.
Showroom mode is
switched on.
The LED light is defective.
Appliance was open too
long.
Light is switched off after
approx. 10 min.
Appliance opened
frequently.
Too much food was placed in
the compartment.
The airing and ventilation
openings are blocked.
Freezer compartment door is
open.
Too much food was placed
in the freezer compartment
at once.
Remedial action
Press the On/Off button.
Check whether the power is on.
Check the fuse.
Check whether the mains plug is secure.
Hold down alarm button, Fig "/1, for
10 seconds until an acknowledgement signal
sounds.
After a short time check whether your
appliance is cooling.
See chapter "Light (LED)" section.
When the appliance is closed and opened,
the light is on again.
Do not open the appliance unnecessarily.
Before placing food in the freezer, press the
super button 5.
Remove obstacles.
See chapter entitled "Alarm functions".