Electrolux EWC 1350 User Manual page 19

Authorised Service Centre, please carry
out the checks listed below.
During machine operation it is possible
that the pilot light D blinks to indicate that
the machine is not working:
• 1 flash: problem with the water
supply.
• 2 flashes: problem with the water
draining.
11.2 Possible failures
Problem
The machine does not
start:
The machine does not
fill:
The machine fills then
empties immediately:
The machine does not
empty and/or does not
spin:
• 4 flashes: door open.
Once the problem has been eliminated,
press the button
programme. If after all checks, the
problem persists, contact your
Authorised Service Centre.
Possible cause/Solution
The door has not been closed.
• Close the door firmly.
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The selector dial is not correctly positioned and the but‐
ton Start has not been pressed.
• Please turn the selector dial and press the button
Start again.
The water tap is closed.
• Open the water tap.
The inlet hose is squashed or kinked.
• Check the inlet hose connection.
The filter in the inlet hose is blocked.
• Clean the water inlet hose filter.
The door is not properly closed.
• Close the door firmly.
The end of the drain hose is too low.
• Refer to relevant paragraph in «Installation» chapter.
The drain hose is squashed or kinked.
• Check the drain hose connection.
An option or a programme that ends with the water still
in the tub or that eliminates all the spinning phases has
been selected.
• Select the draining or spinning programme.
The laundry is not evenly distributed in the drum.
• Redistribute the laundry.
ENGLISH
to restart the
19