Heated Seats - If Equipped - Chrysler 300 2018 User Manual

forward of the rear stop. The seat will return to its
previously set position when you cycle the vehi-
cle's ignition to the ACC or RUN position.
• The Easy Entry/Easy Exit feature is disabled when
the driver seat position is less than 0.9 of an inch
(22.7 mm) forward of the rear stop. At this posi-
tion, there is no benefit to the driver by moving the
seat for Easy Exit or Easy Entry.
Each stored memory setting will have an associated
Easy Entry and Easy Exit position.
NOTE:
The Easy Entry/Exit feature is not enabled when the
vehicle is delivered from the factory. The Easy
Entry/Exit feature is enabled (or later disabled)
through the programmable features in the
Uconnect system. Refer to "Uconnect Settings" in
"Multimedia" in your Owner's Manual for further
details.
22
Heated Seats — If Equipped
On some models, the front and rear seats may be
equipped with heaters located in the seat cushions
and seat backs.
WARNING!
• Persons who are unable to feel pain to the skin
because of advanced age, chronic illness, dia-
betes, spinal cord injury, medication, alcohol
use, exhaustion or other physical condition
must exercise care when using the seat heater.
It may cause burns even at low temperatures,
especially if used for long periods of time.
• Do not place anything on the seat or seatback
that insulates against heat, such as a blanket or
cushion. This may cause the seat heater to
overheat. Sitting in a seat that has been over-
heated could cause serious burns due to the
increased surface temperature of the seat.
Front Heated Seats
The front heated seats control buttons are located
within the climate or controls screen of the touch-
screen.
You can choose from HI, LO, or OFF heat settings.
The indicator arrows in touchscreen buttons indi-
cate the level of heat in use. Two indicator arrows
will illuminate for HI, and one for LO. Turning the
heating elements off will return the user to the radio
screen.
• Press the heated seat button
HI setting on.
• Press the heated seat button a second time to
turn the LO setting on.
• Press the heated seat button
turn the heating elements off.
If the HI-level setting is selected, the system will
automatically switch to LO-level after approxi-
mately 60 minutes of continuous operation. At that
time, the display will change from HI to LO, indicat-
ing the change. The LO-level setting will turn off
automatically after approximately 45 minutes.
NOTE:
• Once a heat setting is selected, heat will be felt
within two to five minutes.
• The engine must be running for the heated seats
to operate.
once to turn the
a third time to