Miele KM 5670 Operating And Installation Instructions page 42

Problem solving guide
... the food in the pan hardly heats up
or does not heat up at all when the
Auto heat-up function is switched on
This could be because:
– there is too much food in the pan.
– the pan is not conducting heat
properly.
Select a higher continued cooking
setting next time, or start cooking at the
highest setting and then turn down to a
lower setting manually later on.
... it seems to take too long for a pan
of food to reach the required
temperature
See "To test the power level".
... one or more residual heat
indicators are flashing
– There was an interruption to the
power supply during operation, and
the cooktop has switched itself off.
The cooktop can be used again as
normal.
Check the cooking stage of the food
and whether its condition has been
affected by the power failure before
switching the cooking zone(s) back on
again.
– The residual heat indicators have lit
up during programming.
42
... numbers light up in the Timer
display, and A, F and numbers light
up in the cooking zone display, when
the cooktop is switched off.
The sensitivity level of the sensors has
altered and cannot recalibrate
automatically. The sensors must be
recalibrated manually (see "Calibrating
the sensor switches").
If this does not solve the problem,
please call the Miele Customer Contact
Centre.
... an F appears in the display for the
left hand cooking zones, an E
appears in the display for the right
hand cooking zones and numbers
appear in the timer display.
Interrupt the power supply to the
cooktop for approx. 1 minute.
If the problem persists after
reconnecting the appliance to the
power supply, please contact the Miele
Customer Contact Centre.