Main Parts Specifications Dr. Nikolas Stihl Maintenance and Repairs Disposal EC Declaration of Conformity This instruction manual is protected by copyright. All rights reserved, especially the rights to reproduce, translate and process with electronic systems. HS 87 R, HS 87 T...
Do not lend or rent your power tool without the instruction manual. Be sure that anyone using it understands the information contained in this manual. HS 87 R, HS 87 T...
Page 5
STIHL or are technically identical. If you have any questions in this respect, consult a servicing dealer. Use only high quality tools and accessories in order to avoid the risk of accidents and damage to the machine.
Page 6
– free from oil and dirt – for safe control of the power tool. To reduce the risk of accidents, do not operate your power tool if it is damaged or not properly assembled. HS 87 R, HS 87 T...
Page 7
Check and correct the idle designed (e.g. heavy impact or a fall), speed setting regularly. always check that it is in good condition before continuing work – see also HS 87 R, HS 87 T...
Page 8
If the hedge is very dusty or dirty, spray result in vibration-induced circulation it is damaged. In case of doubt, consult the blades with STIHL resin solvent from problems in the hands (whitefinger your servicing dealer. time to time during cutting. This helps disease).
STIHL recommends the use of original STIHL replacement parts. They are specifically designed to match your model and meet your performance The HS 87 R is designed for cutting requirements. hedges and shrubs with thicker stems and branches. To reduce the risk of injury, always shut...
Page 10
Any working position above head height hedge with the aid of the optional is tiring. To minimize the risk of catcher plate on the cutting blade. accidents, work in such positions for short periods only. HS 87 R, HS 87 T...
Use only high-quality two-stroke engine STIHL MotoMix uses STIHL HP Ultra location protected from light and the sun. oil – preferably STIHL HP, HP Super or two-stroke engine oil for an extra long Fuel mix ages – only mix sufficient fuel HP Ultra, which are specially formulated engine life.
Take care not to spill fuel while fueling Raise the grip until it is upright. and do not overfill the tank. STIHL recommends you use the STIHL filler nozzle for fuel (special accessory). Fill up with fuel. HS 87 R, HS 87 T...
Page 13
Turn the cap clockwise and lock it in position – see section on "Closing". The marks on the tank cap and fuel tank are then in alignment. HS 87 R, HS 87 T...
Now start the engine. out on the palm of your hand or blow it out with compressed air. Do not wash. Install the filter element. Fit the filter cover. Insert screw and tighten it down firmly. HS 87 R, HS 87 T...
(no (despite correction to setting of LA more than 3/4 turn). screw). Turn the low speed screw (L) Idle setting is too lean clockwise as far as stop, then turn it back 3/4 turn. HS 87 R, HS 87 T...
Arcing may occur if the adapter nut (1) is lubrication and overheating. loose or missing. Working in an easily combustible or explosive atmosphere may cause a fire or an explosion. This can result result in serious injuries or damage to property. HS 87 R, HS 87 T...
Remove the screw plug (1) from the gear housing on the underside of the unit. Screw the tube of grease (2) into the filler hole. Squeeze up to 5 g grease into the gearbox. HS 87 R, HS 87 T...
STIHL resin solvent. NOTICE Do not operate your machine with dull or damaged cutting blades. This may cause overload and will give unsatisfactory cutting results. HS 87 R, HS 87 T...
Readjust electrode gap Spark plug Replace after every 100 operating hours Visual inspection Cooling inlets Clean All accessible screws and nuts (not adjust - Retighten ing screws) Visual inspection Anti-vibration elements Have replaced by servicing dealer HS 87 R, HS 87 T...
Page 21
Have replaced by servicing dealer Adjust blade clearance Check and replenish after every 25 Gearbox lubrication hours of operation Safety labels Replace STIHL recommends an authorized STIHL servicing dealer. not in all versions, market-specific or available as option HS 87 R, HS 87 T...
Rewind starter – servicing dealer. Spark plug – STIHL recommends that you have Components of antivibration system – servicing and repair work carried out exclusively by an authorized STIHL HS 87 R, HS 87 T...
Vibration measurement a hv,eq When repairing the machine, only use ISO 22867 (with tip guard) replacement parts which have been approved by STIHL for this power tool or HS 87 T are technically identical. Only use high- Handle, Handle, quality replacement parts in order to...
Category: Hedge trimmer Make: STIHL Model: HS 87 T HS 87 R STIHL products must not be thrown in Thomas Elsner Serial identification: 4237 the garbage can. Take the product, Displacement: 22.7 cc Director Product Management and accessories and packaging to an...