Specifications; Operation - Porter-Cable PTX5 Instruction Manual

Strokes Per Minute
Maximum Working Pressure
Blade Type
Air Inlet
Recommended Hose Size
Air Consumption @ 90 PSI
Accessories Required
IMPORTANT: Line pressure or hose inside diameter should be increased to compensate
for unusually long air hoses (over 25 feet). Minimum hose diameter should be 3/8" I.D.
and fittings should have 1/4" NPT thread.

Operation

Before each use:
G
Drain water from air compressor tank and condensation from air lines. See air
compressor's operators manual.
G
Lubricate tool, see "Maintenance" section in this manual.
G
Select the required saw blade. See chart.
G
Loosen the hex head screw (A), using wrench supplied.
G
Insert blade (C) and tighten hex head screw (A).
G
Connect tool to air hose of recommended
size. NOTE: The use of a quick connect
set makes connecting easier.
IMPORTANT: The use of air filters and air
line lubricators is recommended.
To use:
G
Turn air compressor on and allow air tank
to fill.
G
Set the air compressor's regulator to 90 PSI. This tool operates at a maximum 90
PSI pressure.
G
Depress the throttle safety release and throttle control lever to operate tool.
IMPORTANT: Do not force. Too much pressure can cause blade to overheat and
break. Too little pressure will keep blade from cutting and cause it to overheat.
G
Reduce pressure just before cutting through the work. When saw has completed cut,
remove from the workpiece while the motor is running, then release throttle.
G
Release throttle control lever to stop tool.
G
Always disconnect air supply when changing blades.
G
When job is complete, turn the air compressor off and store as described in the air
compressor operator manual.

SPECIFICATIONS

ASSEMBLY
OPERATION
Disconnect the saw from the air supply before lubricating or
changing blades.
5,000
90 PSI
32 teeth/24 teeth
1/4" NPT
3/8" I.D.
2.0 SCFM
A
5- ENG
Number Used
of teeth to cut
24 wood
32 metal
C