Porsche 944 Workshop Manual page 59

944
7. Disconnect breather hose for
toothed helt cover at rear of
lower section of air filter.
Unbolt filter assembly as a unit
and remove.
8. Remove air-flow sensor.
9. Slacken and remove
ignition-distributor cap and
rotor. (Mark installation
position of rotor). Remove oil
filter and ATF reservoir.
Printed in Germany - XIII, 1987
Engine/Crankcase
10. Remove throttle valve actuating
cable complete with reversing
roller and holder. Disconnect
oxygen sensor plug connector.
Slacken hose clamps at intake
manifold and brake booster and
disconnect hoses.
11. Remove cable clips from
bulkhead. Disconnect two-pin and
multi-pin connectors. Disconnect
vacuum hose from tank breather
valve.
Removing and Installing Engine
10
10 - 103