Porsche 944 Workshop Manual page 149

944 S/944 S2
Fault, Fault Code
Connect two-pin DME test lead (Bosch No. 1 684 463 093) between the speed
control and plug.
Connect and adjust engine tester to supplied operating instructions.
Make sure that electric lead connections do not have contact with vehicle ground
(danger of short).
Displayed with the engine running:
Frequency: approx. 100 Hz.
Replace the idle speed control it the pulse cannot be heard in spite of correct
power supply and received signal.
Test Point
Oxygen regulation cannot work in its regulating range in case at disturbances in
7
air/fuel mixture; for example: too lean because of excessive air or too rich
Oxygen
because of a sticking fuel injector. It then moves against the stop.
regulation
on stop
Test 1:
Fault Code
1_23
too lean:
too rich:
DME - Diagnosing/Troubleshooting
Printed In Germany - XXI, 1989
Fuel System - Electronic Control
Possible Causes, Elimination, Remarks
Check CO level with the engine running and CO
tester connected (between 0.4 and 1.2 %).
Check intake system for leaks
(Test Point 19).
Check system pressure (Test Point 18).
Check fuel injectors for leaks (Test Point 18).
24/28
D 24/28 - 15