Samsung RMC30D1 User Manual page 27

Radio Frequency Safety Exposure
THIS MODEL MEETS THE U.S. GOVERNMENT'S REQUIREMENTS FOR EXPOSURE
TO RADIO WAVES.
Your wireless device contains a radio transmitter and receiver. Your device is designed
and manufactured not to exceed the emission limits for exposure to radio frequency
(RF) energy set by the Federal Communications Commission of the U.S. Government.
These limits are part of comprehensive guidelines and establish permitted levels of RF
energy for the general population. The guidelines are based on standards that were
developed by independent scientific organizations through periodic and thorough
evaluation of scientific studies.
The exposure standard for wireless mobile devices employs a unit of measurement
known as the Specific Absorption Rate (SAR). The SAR limit set by the FCC is 1.6
W/kg. Tests for SAR are conducted using standard operating positions accepted by
the FCC with the device transmitting at its highest certified power level in all tested
frequency bands. Although the SAR is determined at the highest certified power level,
the actual SAR level of the device while operating can be well below the maximum
value. This is because the device is designed to operate at multiple power levels so as
to use only the power required to reach the network. In general, the closer you are to a
wireless base station antenna, the lower the output.
Before a device model is available for sale to the public, it must be tested and certified
to the FCC that it does not exceed the limit established by the U.S. government-
adopted requirement for safe exposure. The tests are performed on position and
locations (for example, at the ear and worn on the body) as required by FCC for each
model. The highest SAR value for this model as reported to the FCC when tested for
use at the ear is 0.131 W/kg, and when worn on the body, is 0.410 W/kg. (Body-worn
measurements differ among device models, depending upon available accessories and
FCC requirements). While there may be differences between the SAR levels of various
devices and at various positions, they all meet the U.S. government requirement.
The FCC has granted an Equipment Authorization for this model with all reported
SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR
information on this model is on file with the FCC and can be found under the Display
Grant section at https://gullfoss2.fcc.gov/oetcf/eas/reports/GenericSearch.cfm after
search on FCC ID A3LRMC30D1. For body worn operation, this device has been
tested and meets the FCC RF exposure guidelines when used with touch positions
from the body. Non-compliance with the above restrictions may result in violation of
FCC RF Exposure guidelines.
27
RMC30D1_ZA]BN68-03328B-00L03.indb 27 2011-01-11 오후 3:4