SERVICE MANUAL
Ver. 1.1 2006.08
• SA-WSLF10 is the subwoofer in DAV-LF10.
• SS-CTL10 is the center speaker in DAV-LF10.
• SS-TSL10 is the front speaker in DAV-LF10.
• SS-TSL11 is the surround speaker in DAV-LF10.
For the US model
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND
TOTAL HARMONIC
DISTORTION:
With 4 ohm loads, both
channels driven, from
200 – 20,000 Hz; rated
65 watts per channel
minimum RMS power,
with no more than 0.7 %
total harmonic distortion
from 250 milli watts to
rated output.
Amplifier section SA-WSLF10
Stereo mode (rated)
86 W + 86 W (4 ohms at
1 kHz, THD 10 %)
Surround mode (reference) music power output
86
Front:
W (each)
(with SS-TSL10)
Center*:
86
(with SS-CTL10)
Surround*:
86
(with SS-TSL11)
Subwoofer*:
(with SA-WSLF10)
* Depending on the sound field settings and the source,
there may be no sound output.
Inputs
VIDEO/SAT:
Sensitivity: 300 mV
Impedance: 50 kilohms
Sony Corporation
9-879-563-02
Home Audio Division
2006H05-1
Published by Sony Techno Create Corporation
© 2006.08
SA-WSLF10
SS-CTL10
SPECIFICATIONS
Phones
Tuner section SA-WSLF10
System
FM tuner section
Tuning range
North American models: 87.5 – 108.0 MHz
Other models:
Antenna (aerial)
Antenna (aerial) terminals 75 ohms, unbalanced
Intermediate frequency
AM tuner section
Tuning range
North American models: 530 – 1,710 kHz (with the
W
Other models:
W
W × 2
85
Antenna (aerial)
Intermediate frequency
SS-CTL10/TSL10/TSL11
SS-TSL10 SS-TSL11 STAND ASSY
This system incorporates with Dolby* Digital and Dolby Pro Logic (II)
adaptive matrix surround decoder and the DTS** Digital Surround
System.
* Manufactured under license from Dolby Laboratories.
"Dolby", "Pro Logic", and the double-D symbol are trademarks of
Dolby Laboratories.
**Manufactured under license from Digital Theater Systems, Inc.
"DTS", "DTS-ES", and "DTS Digital Surround" are trademarks of
Digital Theater Systems, Inc.
Video section SA-WSLF10
Accepts low-and high-
impedance headphones.
Outputs
PLL quartz-locked digital
synthesizer system
Inputs
(100 kHz step)
87.5 – 108.0 MHz
Speakers
(50 kHz step)
FM wire antenna (aerial)
Fro
Speaker system
10.7 MHz
Speaker unit
interval set at 10 kHz)
531 – 1,710 kHz (with the
Rated impedance
interval set at 9 kHz)
Dimensions (approx.)
530 – 1,710 kHz (with the
interval set at 10 kHz)
531 – 1,602 kHz (with the
interval set at 9 kHz)
AM loop antenna (aerial)
450 kHz
SA-WSLF10/
US Model
E Model
Australian Model
Video: 1 Vp-p 75 ohms
S video:
Y: 1 Vp-p 75 ohms
C: 0.286 Vp-p 75 ohms
COMPONENT:
Y: 1 Vp-p 75 ohms
P
/C
, P
/C
: 0.7 Vp-p
B
B
R
R
75 ohms
Video: 1 Vp-p 75 ohms
nt SS-TSL10
Two-way bass reflex,
magnetically shielded
50 mm (2 inches) dia. cone
type × 2, 25 mm (1 inch)
dia. balance-dome-type
tweeter
4 ohms
68 × 380 × 53 mm (2
15 × 2
1
/
inches) (w/h/d)
8
220 × (398 – 530) × 220
3
× (15
3
mm (8
/
/
4
× 8
3
/
inches) (w/h/d) with
4
stand
– Continued on next page –
SPEAKER SYSTEM
×
3
/
4
7
– 20
/
)
4
8