HP 5500 HI Series Configuration Manual page 296

[SwitchA-Vlan-interface1] ipsec policy map1
2. Configure Switch B:
# Assign an IP address to VLAN-interface 1.
<SwitchB> system-view
[SwitchB] interface vlan-interface 1
[SwitchB-Vlan-interface1] ip address 2.2.3.1 255.255.255.0
[SwitchB-Vlan-interface1] quit
# Define an ACL to identify data flows from Switch B to Switch A.
[SwitchB] acl number 3101
[SwitchB-acl-adv-3101] rule 0 permit ip source 2.2.3.1 0 destination 2.2.2.1 0
[SwitchB-acl-adv-3101] rule 5 permit ip source 2.2.2.1 0 destination 2.2.3.1 0
[SwitchB-acl-adv-3101] quit
# Create an IPsec proposal named tran1.
[SwitchB] ipsec proposal tran1
# Specify the encapsulation mode as tunnel.
[SwitchB-ipsec-proposal-tran1] encapsulation-mode tunnel
# Specify the security protocol as ESP.
[SwitchB-ipsec-proposal-tran1] transform esp
# Specify the algorithms for the proposal.
[SwitchB-ipsec-proposal-tran1] esp encryption-algorithm aes 128
[SwitchB-ipsec-proposal-tran1] esp authentication-algorithm sha1
[SwitchB-ipsec-proposal-tran1] quit
# Configure the IKE peer.
[SwitchB] ike peer peer
[SwitchB-ike-peer-peer] pre-shared-key Ab12<><>
[SwitchB-ike-peer-peer] remote-address 2.2.2.1
[SwitchB-ike-peer-peer] quit
# Create an IPsec policy that uses IKE for IPsec SA negotiation.
[SwitchB] ipsec policy use1 10 isakmp
# Apply the ACL.
[SwitchB-ipsec-policy-isakmp-use1-10] security acl 3101
# Apply the IPsec proposal.
[SwitchB-ipsec-policy-isakmp-use1-10] proposal tran1
# Apply the IKE peer.
[SwitchB-ipsec-policy-isakmp-use1-10] ike-peer peer
[SwitchB-ipsec-policy-isakmp-use1-10] quit
# Apply the IPsec policy group to VLAN-interface 1.
[SwitchB] interface vlan-interface 1
[SwitchB-Vlan-interface1] ipsec policy use1
3. Verifying the configuration
After the previous configuration, send traffic from Switch B to Switch A. Switch A starts IKE negotiation
with Switch B when receiving the first packet. If IKE negotiation is successful and SAs are set up, the traffic
between the two switches will be IPsec protected.
283