Chapter 4. Connecting The Residential Voip Cable Modem To Your Computer - Huawei CG1241 Quick Start Manual

Chapter 4. Connecting the Residential VoIP cable modem to Your Computer

Installation Procedure for Ethernet Interface
Follow the steps below for proper installation:
1. Ensure the ON/OFF switch, on the rear panel, is on position ON = '1'.
2. Connect one end of the coaxial cable to the CABLE connection on the wall, and the other
end to the CABLE jack on the CG1241/CG1241D.
3. Connect the plug from the power supply into the POWER jack on the CG1241/CG1241D,
and plug the power supply into an AC outlet.
Note: Use only the power supply that accompanied this unit. Using other adapters may
damage the unit.
4. Connect one end of the Ethernet cable to the Ethernet port on the back of your computer,
and the other end to the ETHERNET port on the CG1241/CG1241D.
5. Press the Power Button, switch ON the device.
6. The CG1241/CG1241D will look for the proper cable modem signal in the Cable
Television network and process the initial registration. The voice gateway is ready for
data transfer after the LED "Cable Link" is lit solid green.
Note: The REBOOT button at the rear panel is for maintenance purposes only. You
don't need to use it.
Fig. How to set up your connection
5