Fujitsu AU*G30LRLE series Service Instruction page 65

1-4. Outlet directions (For AU type)
Select the setting values in the table below for using a 3-way outlet.
Setting Description
4-way
3-way
1-5. Vertical direction adjusting scope (For AU type)
To prevent from draft, we recommend using "upward mode".
Setting Description
Standard
Upward
1-6. Setting the Cooler room temperature correction
Depending on the installed environment, the room temperature sensor may require a correction.
The settings may be selected as shown in the table below.
Setting Description
Standard
Slightly lower control
Lower control
Warmer control
1-7. Setting the Heater room temperature correction
Depending on the installed environment, the room temperature sensor may require a correction.
The settings may be changed as shown in the table below.
Setting Description
Standard
Lower control
Slightly warmer control
Warmer control
1-8. Setting the Auto restart
Enable or disable automatic system restart after a power outage.
Setting Description
Yes
No
Auto restart is an emergency function such as for power failure etc.
Do not start and stop the indoor unit by this function in normal operation.
Be sure to operate by the control unit, or external input device.
(
Function Number Setting Value
22
(
Function Number Setting Value
23
( Factory setting)
Function Number
30
( Factory setting)
Function Number Setting Value
31
( Factory setting)
Function Number Setting Value
40
03-02
Factory setting)
00
01
Factory setting)
00
01
Setting Value
00
01
02
03
00
01
02
03
00
01