HP Netserver LP2000r Service Manual page 78

Chapter 6
2. Remove the drive:
a. Using both hands, grasp the ejector arms and firmly pull the drive out about an inch to
disengage the connection on the backplane.
b. Wait about 30 seconds for the drive to stop spinning and for the drive heads to park.
c. Use your hand to support the bottom of the drive, while you slowly pull the drive straight out.
Do not allow the drive to fall.
3. Place the drive in an electrostatic protected container. Do not stack drives.
72
Opening Drive Ejector Arms
Removing a SCSI Drive
Replacing Parts