Installing And Removing The Battery And Card - Canon EOS Rebel SL2 Basic Instruction Manual

Installing and Removing the Battery and Card

Load a fully charged Battery Pack LP-E17 into the camera. The camera
can use an SD, SDHC, or SDXC memory card (sold separately). UHS-I
Speed Class SDHC and SDXC memory cards can also be used. The
captured images are recorded onto the card.
Make sure the card's write-protect switch is set upward to
enable writing/erasing.
Installing the Battery and Card
Write-protect switch
32
Open the cover.
1
Slide the lever as shown by the
arrows and open the cover.
Insert the battery.
2
Insert the end with the battery
contacts.
Insert the battery until it locks in
place.
Insert the card.
3
As shown by the illustration, face
the card's label side toward the
back of the camera and insert it
until it clicks in place.
Close the cover.
4
Press the cover until it snaps shut.
When you set the power switch to
<1>, the number of possible shots
(p.36) will be displayed on the LCD
monitor.