Advertisement
..
SILK/RAYON/POLYESTER
...
WOOL/COTTON/LINEN
The pilot lamp will switch off when the selected temperature has been reached and ironing can commence.
The light will cycle on an off as the temperature is regulated.
FILLING WITH WATER
1. Before filling with water, ensure that the iron is unplugged from the mains.
2. Turn the temperature control to the "." position
3. Open the water cover and then fill in water to the maximum level mark only.
DRY IRONING
1. Turn the temperature control dial to the temperature indicated on the garments "Care Instructions" label.
2. Stand the iron upright on a smooth and stable surface.
3. After the indicator lamp switches off, the iron is ready for use.
SPRAY FUNCTION
a) Press the spraying button repeatedly to produce a fine mist from the spray nozzle.
b) Always ensure that there is sufficient water in the water reservoir.
STEAM-IRONING
1. As indicated on the temperature control and the table on the iron, steam-ironing is only possible at higher
ironing temperatures: "..." or "MAX".
2. Ensure that there is enough water in the water reservoir
3. Stand the iron upright.
4. Set the temperature control at the required position within the steam area
5. Insert the plug into the wall socket
6. After the indicator lamp has switched off and cycled on again, the iron is ready for use.
7. Slide the knob to the required position.
BURST OF STEAM
This function can be used only at higher ironing temperatures and provides an extra burst of steam to remove
stubborn wrinkles.
1. Fill water into the iron as described above to the maximum mark.
2. Stand the iron upright.
3. Connect the iron to a suitable mains supply outlet.
4. Turn the temperature control dial to the MAX setting and allow the iron time to heat up to the set
temperature. The pilot light will turn off when the required temperature is reached. The iron is ready for
use.
5. Press the Burst of Steam button once.
6. Steam will penetrate into the garment removing wrinkles.
7. Wait a few seconds before pressing the Burst of Steam button again. Usually 3 bursts of steam will be
sufficient to remove stubborn wrinkles.
NOTE: With conventional steam ironing, water may leak from the sole plate if a too low temperature has
Advertisement
