LG C1150 Service Manual page 97

5. DOWNLOAD AND CALIBRATION
LED Number
LED 1
LED 2
LED 3
LED 4
1. Connect as Fig 6-2(RS232 serial cable is connected between COM port of PC and MON port of
TEST JIG, in general) 2. Set the Power Supply 4.0V
3. Set the 3rd, 4th of DIP SW ON state always
4. Press the Phone power key, if the Remote ON is used, 1st ON state
D. Procedure
1. Connect as Fig 6-2(RS232 serial cable is connected between COM port of PC and MON port of
TEST JIG, in general)
2. Power ON PC then enter into Windows 98(Remark : Windows 2000 system could be feasible)
3. Run AUTOCAL.exe, the AUTOCAL application window will be appeared.
Table 5-4. LED Description
Name
Power
TA Indicate charging state of the phone battery
UART Indicate data transfer state through the UART port
MON Indicate data transfer state through the MON port
- 98 -
Description
Power is provided for Test Jig