Configuration Process - Polycom SpectraLink 8020 Administration Manual

SpectraLink 8020/8030 Wireless Telephone: Administration Guide for SRP

Configuration Process

40
1. Download the latest SpectraLink 8020/8030 Wireless Telephone
software from http://www.spectralink.com/softwareUpdates
2. Place the latest version of the SpectraLink 8020 or 8030 Wireless
Telephone SRP code on the TFTP server and ensure the TFTP
server is started. The five files that are needed must be named:
usb downloader
functional filename
phintl filename
ota downloader
config file
3. See SpectraLink 8000 Telephony Gateway: Administration Guide to set
the TFTP server information.
4. Use the Handset Administration Tool to set up the configuration
of each handset to meet all essential requirements. If not using the
Handset Administration Tool, ensure the following parameters
are correctly set in the Admin menu for each handset: See Chapter
2 SpectraLink 8020/8030 Wireless Telephone Configuration for
detailed configuration instructions.
If statically assigning IP addresses, ensure that the
—
, and
Subnet Mask
using a DHCP Server, ensure that the DHCP option is set.
Ensure the handset has properly configured
—
information.
Domain
Ensure the
—
Telephony Protocol
ensures the handset will check for the proper SRP files each
time it powers on.
Ensure security settings are properly programmed.
—
5. Power cycle the handset.
6. The SRP code will now download to the handset. The status bar
will increment fully across the display for each function that is
being performed in the download process and the filename will
display. Upon completion of the update process, the handset will
re-boot with the new firmware.
pd14udsp.bin
pd14csp.bin
pi1400sp.bin
pd14odsp.bin
slnk_cfg.cfg
information are accurate. If
Default Gateway
menu option is set to
,
Phone IP
and
SSID Reg
. This
030
1725-36030-001_B.doc