Advertisement
© 2000 Agilent Technologies
Figure 19
CFGSNCR.EXE Usage and Output
TO REPEAT:
The configurable parameters are located in C:\5DX\Release
Root\CALIB\SCNR.CFG.
The usage specifies a valid unit address of 1 to 50 for the Microscan 600 series.
ONLY if the address value is out of range will an error message be displayed,
as shown in Figure 20
Figure 20
Error Message for Multidrop Unit Address
If no error message is generated, then proceed to the next step. If an error mes-
sage is displayed, re-check the "scnr.cfg" file for the correct setup.
ADVICE
Again, the current scanner configuration will be displayed as shown in
page 13, and if the baud rate does not match the server baud rate then the same warning
will appear as shown in
baud rate at the default setting of 9600 for a multidrop configuration because the
scanner communicates directly with a concentrator and NOT the PC host. It is still
possible to change the baud rate if necessary.
Automatic Barcode Reader
Figure 20
on page 16. We recommend that you leave the
Figure 15
on
16
Advertisement
