Table of Contents
Advertisement
4. Continue to hold both buttons and observe the indicator light. The HomeLink indica-
tor will flash slowly and then rapidly after HomeLink has received the frequency signal
from the hand-held transmitter. Release both buttons after the indicator light changes
from slow to rapid.
5. At the garage door opener motor (in the garage), locate the "LEARN" or "TRAINING"
button. This can usually be found where the hanging antenna wire is attached to the garage
door opener motor. Firmly push and release the "LEARN" or "TRAINING" button.
NOTE:
You have 30 seconds in which to initiate the next step after the "LEARN" button has
been pushed.
6. Return to the vehicle and push the programmed HomeLink button twice (holding the
button for two seconds each time). If the device is plugged in and activated, program-
ming is complete.
NOTE:
If the device does not activate, push the button a third time (for two seconds) to com-
plete the training.
7. To program the remaining two HomeLink buttons, repeat each step for each remain-
ing button. DO NOT erase the channels.
Programming A Non-Rolling Code
NOTE:
For programming Garage Door Openers manufactured before 1995.
1. Place the ignition switch to the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLink
button you wish to program while keeping the HomeLink indicator light in view.
3. Push and hold the HomeLink button you want to program while you push and hold
the hand-held transmitter button.
4. Continue to hold both buttons and observe the indicator light. The HomeLink indica-
tor will flash slowly and then rapidly after HomeLink has received the frequency signal
from the hand-held transmitter. Release both buttons after the indicator light changes
from slow to rapid.
5. Push and hold the programmed HomeLink button and observe the indicator light. If
the indicator light stays on constantly, programming is complete and the garage door
(or device) should activate when the HomeLink button is pushed.
6. To program the two remaining HomeLink buttons, repeat each step for each remain-
ing button. DO NOT erase the channels.
ELECTRONICS
121
Advertisement
Table of Contents
