Table of Contents
Advertisement
ELECTRONICS
NOTE:
If an SMS is sent through Uconnect, an additional cost may be incurred on the mobile
phone sending the message. For more information, please contact your phone provider.
Once your Uconnect system is paired with a compatible mobile device, the system can
announce a new incoming text message, and read it to your over the vehicle audio sys-
tem. You can reply to the message using Voice Recognition by selecting, or saying, one of
the 18 pre-defined messages.
Here's How:
1. Push the Uconnect Phone button
Uconnect will give the following prompt: "Please say the message you would like to
send."
2. Wait for the beep and say one of the pre-defined messages. (If you are not sure, you
can say "help"). Uconnect will then read the pre-defined messages allowed.
3. As soon as you hear the message you would like to send, you can interrupt the list of
prompts by pushing the Uconnect phone button and saying the phrase. Uconnect will
confirm the message by reading it back to you.
4. Push the Phone button and say "Send."
PRE-DEFINED VOICE TEXT REPLY RESPONSES
Yes.
No.
Okay.
Call me.
I'll call you later.
I'm on my way.
I'm lost.
*Use only the numbers listed (in increments of five up to 60 minutes) or the system will
not transpose the message.
114
and wait for the beep, then say "reply."
Stuck in traffic.
Start without me.
Where are you?
Are you there yet?
I need directions.
Can't talk right now.
See you later.
I'll be late.
I will be <5, 10, 15, 20, 25,
30, 45, 60>* minutes late.
See you in <5, 10, 15, 20, 25,
30, 45, 60>* minutes.
Thanks.
Advertisement
Table of Contents
