Setting To Stand-Alone Mode - Polaroid PDC-2000 User Manual

Setting to stand-alone
mode
42
When you press the Power button, the camera performs a
brief self-test, then displays a normal LCD panel. If the sound
indicators are enabled, the camera also emits a short,
high-pitched tone to indicate that it passed the self-test and is
ready to take pictures.
If the camera detects any problems or errors during its
self-test, it displays an error message on the LCD and emits
one or two short, low-pitched tones. (For more information
about error messages, see Troubleshooting error messages on
page 111.)
If your PDC-2000 camera is connected to a computer, you
must release it from computer control to operate in the
stand-alone mode.
Use either of these two methods to release it:
Use the computer to release the camera. (See Releasing the
camera from computer control, page 80 for Macintosh or
page 102 for PC.)
Disconnect the camera from the computer. (See Disconnecting
the camera from your computer on page 29.)
WARNING: DO NOT DISCONNECT OR CONNECT
ANY DEVICE WHILE THE DEVICE OR YOUR
COMPUTER IS TURNED ON. DOING SO COULD
DAMAGE THE DEVICE, YOUR COMPUTER, OR BOTH.