Table of Contents
Advertisement
7. Level 2 Repair
7-2. Assembly
1
Soldering 2 points of MIC FPCB pad with
PBA
1) Be careful not to make scratch and molding damage!
3
Combine LCD to Main Board.
1) Be careful not to make scratch and molding damage!
2) Don't push the panel of LCD while combine the LCD
This Document can not be used without Samsung's authorization
SAMSUNG Proprietary-Contents may change without notice
2
Soldering FPCB of the LCD MODULE
Check F-PCB to MAIN PCB soldering tightly.
(If there is a gap between F-PCB and Main board will
makes faulty)
Be careful not to make Flux on the Main
(Use the cover of Soldering Jig)
1) Be careful not to make scratch and molding damage!
2) Be careful not to make a gap between LCD FPCB
and Main Board.
3) Height of solder should not over 0.2mm.
4
Assemble the SHIELD CAN
1) Be careful not to make scratch and molding damage!
(Torque: 1.2)
7-4
CAUTION
Board
Hide quick links:
Advertisement
Table of Contents
