Programming A Sequence - Metrologic MS7120 Scanner Setup Manual

Programming a Sequence

To program a sequence, proceed as follows:
Scan the bar code as shown in
1
Scan the bar codes one at a time in the order given in the following table.
2
Note: When scanning the bar codes in
Each bar code has a page number in a note under it that corresponds to the hard copy page in
00-02407 Metrologic Instruments Inc. MetroSelect
scanner. If the bar code cannot be read from
use the 00-02407 Configuration Guide.
Note: A PDF version of 00-02407 Metrologic Instruments, Inc. MetroSelect Configuration
Exit the program mode by scanning in the bar code in
3
The scanner should now be properly programmed. Repeat the procedure in
4
Verification Sequence" on page 6
Note: If the scanner does not work after following all the instructions listed above, it indicates
MDE-4631 Metrologic® MS7120 Bar Code Scanner Setup · January 2007
Figure 14 on page
may help to rotate them.
Scan Order
Profit Point PLUS
1 Figure 14 on page 14
2 Figure 2 on page 8
3 Figure 3 on page 8
4 Figure 5 on page 9
5 Figure 7 on page 10
6 Figure 10 on page 12
7 Figure 11 on page 12
8 N/A
9 N/A
Guide is available at the following URL:
ftp://ftp.metrologic.com/pub/download/productmanuals/00-02407.pdf
that the scanner may not be connected properly or the Profit Point POS terminal may
not be configured correctly. Repeat the procedure in
page 5. See the Hardware Configuration section in MDE-4356 Profit Point Reference
Manual to determine if the Profit Point POS terminal is configured correctly.
14.
Figure 2 on page 8
Profit Point Model
Configuration Guide included with the
®
Figure 2 on page 8
Figure 14 on page
to ensure proper programming.
Programming a Sequence
through Figure 14 on page
NT Profit Point
~ OR ~
DOS Profit Point
Figure 14 on page 14
Figure 2 on page 8
Figure 4 on page 9
Figure 6 on page 10
Figure 8 on page 11
Figure 9 on page 11
Figure 10 on page 12
Figure 12 on page 13
Figure 13 on page 13
through Figure 14 on page
14.
"Performing the
"Setting Up the Scanner" on
14, it
14,
Page 7