Cycle Time / Model; Cycle / Programe Guide - Whirlpool W11028050 User Manual

Cycle Time

Cycle Time / Model :

Stainwash Deep clean 7.5kg - WTW750AF
th
Note : Cycle time is given only for manual water level selection. 6 Sense automatically calculates timing based on the wash load and will be indicated as
'Auto' water level.
Excludes fill and drain time. Timings shown here are active wash cycle times.
'Express wash' option is not available for P4,P6,P7, P9 & P11 programs.
To achieve the best performance, water fills up to 40% of overall volume and agitation starts, dissolving the detergent effectively to activate the enzymes.
This will be followed by Fill + agitation to enhance performance ( Applicable in High / V High water levels ). Low water wash is design intent.
Due to continuous R&D, the above timings and sequence may change without prior notice. Timings may vary from model to model and are indicative in nature.
Based on the input water temperature, voltage and water level for each program, cycle time will vary and may not match the display time.
18

Cycle / Programe Guide

Wash C
Hard Water Wash
M C
Hard Water Wash
Eco
C
Hard Water Wash
M C
Germ Free/Cold
Anti-Bac
Bedsheet
Hard Water Wash
and
C
Wash only
M C
Hard Water Wash
The programme used for the evaluation of (WTW808AF) under the mandatory Water Efficiency Labelling Scheme (WELS) and
the recommended Washing Programme for soiled clothes is as follows : P5-Eco
and
and
Rinse and Spin is set in default mode.
Rinse and Spin is set in default mode.
and
3.0kg Maximum for 8.0kg capacity
Rinse and Spin is set in default mode.
Germ Free is set in default mode.
and
1.5
maximum for 8.0kg capacity
Rinse and Spin is set in default mode.
and
and
Rinse and Spin is set in default mode.
Very Hot is set in default mode.
W L
1.5 maximum for 8.0kg capacity
and Spin set in default mode.
Warm is set in default mode.
W L and S O
7.5kg maximum
Rinse and Spin is set in default mode.
Warm is set in default mode.
Double Rinse and Spin is set in default mode.
Germ Free is set in default mode.
W L and S O
1.5 maximum for 8.0kg capacity
Rinse and Spin is set in default mode.
Double Rinse and Spin is set in default mode.
This cycle uses a spin cycle to shorten drying items for heavy fabrics.
and
and
Soak, Wash is set in default mode. (
Water will not be drained after
'wash only' cycle, this detergent water can be reused for the next cycle.)
11