Toe Alignment - Polaris Trailboss 7174820 Owner's Manual

MAINTENANCE AND LUBRICATION

Toe Alignment

WARNING
Severe injury or death can result from improper toe alignment and
adjustment. Do not attempt to adjust tie rod alignment. All tie rod
adjustments should be performed by an authorized Polaris dealer.
Use the following procedure to check the toe alignment of the vehicle.
The recommended toe alignment is 1/8" to 1/4" (3-6 mm) toe out.
1. Position the vehicle on
a level surface.
2. Set the handlebars in a
straight-ahead position
and secure them in
this position.
3. Place a chalk mark on
the center line of the
front tires approximately
10" (25.4 cm) from the
floor, or as close to the
hub/axle center line as
possible. Make sure both
marks are the same distance
from the floor.
4. Measure the distance between the marks and record the
measurement (A).
5. Move the vehicle until the chalk marks are at the rear of the tires,
even with the hub/axle centerline.
6. Measure the distance between the marks and record the
measurement (B).
7. Subtract measurement B from measurement A. The difference is
the vehicle toe-out alignment.
NOTE: If you discover improper alignment, see your Polaris dealer
for service.
70
A
B