Steering Assembly; Camber And Caster; Rear Spring - Polaris TRAIL BLAZER 330 Owner's Manual

MAINTENANCE
Brakes
1. Check the brake system for fluid leaks.
2. Check the brakes for excessive travel or
spongy feel.
3. Check the friction pads for wear,
damage and looseness.
4. Check the security and surface
condition of the disc.
NOTE: Pads should be changed when
worn to 3/64" (.1 cm).
Auxiliary Brake
The auxiliary brake system is intended to be used as a backup for the
main brake system. Should the main system fail, the rear brake can be
activated by depressing the foot pedal on the inside of the right
footrest. The hydraulic auxiliary brake system requires no adjustment.
NOTE: Since this is a rear brake only, it will not be as effective as
the all-wheel single lever system.

Steering Assembly

The steering assembly of the ATV should be checked periodically for
loose nuts and bolts. If loose nuts and bolts are found, see your Polaris
dealer for service before operating the vehicle.

Camber and Caster

The camber and caster are non-adjustable.

Rear Spring

The rear shock absorber spring is
adjusted by rotating the adjuster (1)
either clockwise or counterclockwise
to increase or decrease spring
tension.
NOTE: Accessory springs are
available through your
Polaris dealer.
72
3/64" (.1 cm)
1