Installation Notice - Supermicro SSE-G3648B Installation Manual

E1031 Series switch Installation Guide
The SSE-G3648B/BR switches are designed to be mounted on a standard 19'' rack - please
ensure good ventilation for the rack.
•
Every device in the rack will generate heat during operation, therefore vent and fans
must be provided for an enclosed rack, and devices should not be stacked closely.
•
When mounting devices in an open rack, care should be taken to prevent the rack
frame from obstructing the switch ventilation openings. Be sure to check the positioning
of the switch after installation to avoid the aforementioned.
Caution！If a standard 19'' rack is not available, the SSE-G3648B/BR switches can be placed
on a clean level desktop. Leave a clearance of 100mm around the switch for ventilation and do
not place anything on top of the switch.

Installation Notice

When installing the SSE-G3648B/BR switches do the following:
•
Read through the installation instructions carefully before operating the system. Make
sure the installation materials and tools are prepared. And make sure the installation
site is well prepared.
•
During the installation, users must use the brackets and screws provided in the
accessory kit. Users should use the proper tools to perform the installation. Users
should always wear antistatic uniform and ESD wrist straps. Users should use standard
cables and connecters.
•
After the installation, users should clean the site. Before powering on the switch, users
should ensure the switch is well grounded. Users should maintain the switch regularly
to extend the lifespan of the switch.
•
A statement indicating the location of a readily accessible disconnect device shall be
incorporated in the building installation wiring.
Chapter 2 Installation Notice
30