JVC KW-XC400 Service Manual page 11

3.1.10 Removing the CD mechanism control board
(See Fig.10)
• Remove the front panel assembly, heat sink, rear bracket, bot-
tom chassis assembly and middle chassis assembly.
(1) From the inside of the top chassis assembly, disconnect
the card wire from the connector
anism control board.
(2) Remove the five screws N attaching the CD mechanism
control board.
(3) Lift the CD mechanism control board to remove the joint f
and remove the joint g in the direction of the arrow.
3.1.11 Removing the CD mechanism assembly
(See Fig.11)
• Remove the front panel assembly, heat sink, rear bracket, bot-
tom chassis assembly, middle chassis assembly and CD
mechanism control board.
(1) From the inside of the top chassis assembly, remove the
three screws P attaching the CD mechanism assembly.
(2) Take out the CD mechanism assembly from the top chas-
sis.
Reference:
When attaching the CD mechanism assembly, set the projec-
tions h of the top chassis assembly in the holes of the CD
mechanism assembly.
CN601 on the CD mech-
N
g
N
Top chassis assembly
CN601
CD mechanism control board
Fig.10
P
P
h h
CD mechanism assembly
Top chassis assembly
Fig.11
f
N
(No.MA235)1-11