Polaris 600 HO RMK 155 Owner's Manual page 70

Electronic Reverse (PERCt)
Electronic reverse will activate only if the engine RPM is below 4000.
The maximum engine RPM will be 6000 when in reverse.
Improper reverse operation, even at low speeds, may cause loss of control,
resulting in serious injury or death. Damage will occur to the chaincase or
transmission if shifting is attempted when the engine is operating above idle
speed.
• Shift to or from reverse only when the snowmobile is stopped and when
engine speed is at idle.
• Look behind the snowmobile before and while backing.
• Avoid sharp turns.
• Apply throttle slowly.
Engaging Reverse
1. Stop the snowmobile and leave the
engine idling.
2. Make sure the area behind your snow-
mobile is clear.
3. Push the yellow reverse button on the
left-hand control for one second, then
release. The engine will automatically
reduce RPM and start a reverse rota-
tion.
NOTE:
A reverse light on the instrument panel will indicate that the snowmo-
bile is in reverse.
4. Apply the throttle slowly to make sure the snowmobile is in reverse.
NOTE:
If the engine stops running, the snowmobile will be in forward gear
when it's restarted.
Disengaging Reverse
1. Stop the snowmobile and leave the engine idling.
2. Push the yellow reverse button for one second and release. The
engine will slow and begin to rotate forward. The light on the
instrument panel will shut off.
3. Apply the throttle slowly to make sure the snowmobile is in for-
ward.
WARNING
OPERATION
Reverse Button
67