Installing Firmware On Printer - HP Designjet 3D Service Manual

Installing Firmware on printer

1. From the display panel, press Maintenance.
2. Press System.
3. Press Load Upgrade. "Send upgrade from workstation" and the printer
4. From your workstation, open the HP Designjet 3D Software Solution by
5. Click the Printer Services tab.
6. Select your printer from the drop down list then click the Update Soft-
7. Navigate the HP Designjet 3D Software Solution to the directory where
8. When firmware verification is complete, the printer display will show
-30
IP address will be displayed.
double clicking on the HP Designjet 3D Software Solution icon.
ware button.
the firmware file is located and select the HP Designjet 3D.upg file for
HP Designjet 3D or select the HP Designjet Color 3D.upg file for HP
Designjet Color 3D. Firmware will now begin to download to the printer.
NOTE: The printer will not allow a firmware upgrade file for a
different type of printer. If an upgrade file that is incorrect,
"Upgrade - Invalid Upgrade" will be shown on the display panel.
Reboot to complete upgrade? Press Yes. The printer will then load the
firmware then reboot and return to Idle.
NOTE: Loading firmware will take approximately 10 minutes.