Icom IC-V8000 Optional Instructions page 5

D Calling group stations
q Select the desired ANI set channel.
w When using HM-118TN/TAN:
Push [M M ] then enter the 3-digit group code. [A] or [D] must
be included at least once.
When using HM-133V:
Push [M M (TONE-1)] then enter the 3-digit group code.
[ A(MW)] or [ D(MUTE)] must be included at least
Y
CLR SQL
once.
• Transmits automatically after the 3rd digit code is entered.
• When making group calls, the transceiver does not ring and no
answer back connection code is received.
• You can make an announcement to your group immediately
without a connection procedure.
• " " blinks.
e Operate the transceiver in the normal way (push [PTT] to
transmit; release [PTT] to receive).
r When your conversation is finished, push [#] while pushing
[PTT] , or push [DTMF-S] then [
(HM-118TN/TAN)
L)] to transmit a disconnect code.
(HM-133V)
D Group code examples
[Example 1]: If the "11D (11A)" is transmitted, the trans-
ceivers with ID codes "110" to "119" are called.
[Example 2]: If the "1D3 (1A3)" is transmitted, the trans-
ceivers with ID codes "103," "113,"..."183" and
"193" are called.
NOTE: When "DDD (AAA)" code is transmitted, all trans-
ceivers are called.
D Waiting for a call
q Select
[V//MHz(SCAN)] for 1 sec.
w When receiving a selective call, the display changes as
below, and ringing beeps are heard.
When called from the station
"123."
e Push [PTT] to send a connection code within 10 sec.
#(16KEY-
Z
SQL
• A disconnect code is sent automatically instead of a connection
code in case [PTT] operation is not performed within 10 sec.
r While " " blinks, converse with the connected station.
• Transmitting the disconnect code from your side (push [#] while
pushing [PTT] or push [DTMF-S] then push [
is also available. (except for group call receive)
• " " stops blinking.
ANI FUNCTION
the desired ANI set channel,
During ANI conversation.
1
or push
#(16KEY-L)])
Z
SQL
4