Energy Saving Tips; Installation - Whirlpool ACO450 Instructions For Use Manual

ENERGY-SAVING TIPS
• Install the appliance in a dry, well ventilated room far away from any heat source (e.g. radiator, cooker, etc.) and in a
place not exposed directly to the sun. If required, use an insulating plate.
• To guarantee adequate ventilation follow installation instructions.
• Insufficient ventilation on back of the product increases energy consumption and decreases cooling efficiency.
• The internal temperatures of the appliance may be affected by the ambient temperature, frequency of door opening,
as well as location of the appliance. Temperature setting should take into consideration these factors.
• Allow warm food and drinks to cool down before placing in the appliance.
• After placing the food check if the door of compartments closes properly, especially the freezer door.
• Reduce to a minimum door opening.
• Damaged gasket must be replaced as soon as possible.
• High energy class products are fitted with high efficiency motors that remain operational for longer, but have a low
power consumption. Do not worry if the engine continues to run for longer periods.
APPLIANCE DIAGRAM (Fig. 1)
A. Handle.
B. Safety closure (if provided).
C. Seal.
D. Separator (if provided).
E. Defrost water drain plug.
F. Control panel.
G. Side motor ventilation grille.
CONTROL PANEL DIAGRAM (Fig. 2)
1. Red light: when blinking, it indicates an alarm condition (see the section "TROUBLESHOOTING GUIDE").
2. Blue light: when on, it indicates that the STOP FROST function is activated (see the section "STOP FROST
FUNCTION")
3. Green lights: they indicate that the product is working, the set temperature and possible activation of the quick
freeze function ("Shopping").
4. Setting button: for updating the set temperature, activation/deactivation of the quick freeze function ("Shopping")
and activation/deactivation of the "STOP FROST" function.

INSTALLATION

• Unpack the product.
• Remove the 4 spacers inserted between the lid and the product. (Fig. 3)
• Make sure the defrost water drain plug (if provided) is correctly positioned (E).
• For optimum operation and to avoid damage when the lid is opened, maintain a distance of at least 7 cm from the
front wall and 7 cm at the sides. (Fig. 4)
• Insert the accessories (if provided).
STARTING THE PRODUCT
• Connect the product to the power supply.
• The green light ("Normal") comes on.
• The red light (1) blinks, since the temperature inside the product is not yet low enough for loading food. This light
normally goes off within six hours after startup.
• Place food inside only when the red light has gone off.
Note: If the STOP FROST function is deactivated, the lid cannot be immediately reopened after closing it, because
the seal is tight. It is necessary to wait a few minutes before reopening the lid.