Positive And Negative Pulses; Multi-Level Square Wave; Arbitrary; Hop - Fluke 271 User Manual

Programmable 10 mhz dds function
Hide thumbs Also See for 271:
Table of Contents

Advertisement

Positive and Negative Pulses

Range:
Resolution:
Symmetry control:
Accuracy:
Output level:
Rise and fall times:
Aberrations:

Multi-level Square Wave

Maximum of 16 steps of discrete amplitude (10 bit resolution) and duration (1 to 1024
samples). Allows generation of three-level square wave, staircase, multiplexed LCD
driver signals, etc.
Range:
Output level:
Rise and fall times:

Arbitrary

A number of frequently required waveforms are pre-programmed in the internal read-
only memory (ROM). Waveforms may also be downloaded via the RS232 or GPIB
interfaces and stored in the internal non-volatile random-access memory (RAM).
Frequency range:
Output level:
Sampling frequency:
Number of samples:
Sample levels:

Hop

Up to 16 different waveforms can be output in sequence at a rate determined by either the
internal timer, an external trigger a remote command, or from the keyboard. Each
waveform can be set to any wave shape (except noise), frequency, amplitude and offset.
Frequency-only changes are phase-continuous.

Noise

White noise output with a typical -3 dB bandwidth of 0.03 Hz to 700 kHz. Amplitude and
offset are adjustable. Noise can only be used with gated and AM modes.

Modulation Modes

Continuous

Continuous cycles of the selected waveform are output at the programmed frequency.
info@Fluke-Direct.com
0.1 mHz to 10 MHz
0.1 mHz or 7 digits
1 to 99 % (0.1 % resolution) from 0.1 mHz to 30 kHz
20 to 80 % (0.1 % resolution) from 30 kHz to 10 MHz
10 ppm for 1 year
2.5 mV to 10 V p-p into 50 Ω
<22 ns
<5 % +2 mV
All waveform points are continuously output up to
approximately 27 kHz, above which sampling will introduce
an uncertainty of 1 clock edge (1 clock = 36 ns).
5 mV to 20 V p-p into an open circuit.
<22 ns
0.1 mHz to 10 MHz
Waveform points are continuously output up to
approximately 27 kHz, above which they are sampled.
5 mV to 20 V p-p into an open circuit.
27.48 MHz
1024
1024 (10 bits)
Fluke-Direct
Introduction and Specifications
Specifications
.com
1.888.475.5235
1
1-5

Advertisement

Table of Contents
loading

Table of Contents