Siemens SINUMERIK 840Di Operator's Manual page 11

0
03.02
Notes
Warnings
References
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide CAD Reader (CAD) – 03.02 Edition
The following special notes have been used in this documentation:
This symbol appears in this documentation whenever it is necessary to
draw your attention to an important item of information.
In this documentation, you will find this symbol with a reference to an
ordering option. The function described is executable only if the control
contains the designated option.
The following warning notes with varying degrees of severity are used
in the documentation:
Danger
Indicates an imminently hazardous situation which, if not avoided, will
result in death or serious injury or in substantial property damage.
Warning
Indicates a potentially hazardous situation which, if not avoided, could
result in death or serious injury or in substantial property damage.
Caution
Used with the safety alert symbol indicates a potentially hazardous
situation which, if not avoided, may result in minor or moderate injury
or in property damage.
Caution
Used without safety alert symbol indicates a potentially hazardous
situation which, if not avoided, may result in property damage.
Notice
Used without the safety alert symbol indicates a potential situation
which, if not avoided, may result in an undesirable result or state.
This symbol appears whenever specific information can be found in
other literature.
A complete list of available literature is included in the Appendix of this
Operator's Guide.
Preface
Rules for proper use
0
0-11