Frequency Range - Shure ULXD8 User Manual

Frequency Range

Global
Frequency Range ( MHz )
Band
G50 470 to 534
G51 470 to 534
G52 479 to 534
H50 534 to 598
H51 534 to 598
H52 534 to 565
H53 534 to 598
J50 572 to 636
J51 572 to 636
K51 606 to 670
K52 606 to 670
L51 632 to 696
L52 632 to 694
L53 632 to 714
P51 710 to 782
P52 710 to 782
JB (Tx 806 to 810
only)
Q51 794 to 806
S50 823 to 865
X51 925 to 937.5
X52 902 to 928
X53 902 to 907.500, 915 to 928
X54 915 to 928
Z16 1240 to 1260
Certifications
This device complies with part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
Certified under FCC Part 74, FCC Part 15.
Certified by IC in Canada under RSS-247
and RSS-210,RSS-GEN.
IC: 616A-ULXD6G50, 616A-ULXD6H50,
616A-ULXD6J50, 616A-ULXD6X52,
616A-ULXD8G50, 616A-ULXD8H50,
616A-ULXD8J50, 616A-ULXD8X52.
FCC: DD4ULXD6G50, DD4ULXD6H50,
DD4ULXD6J50, DD4ULXD6X52,
DD4ULXD8G50, DD4ULXD8H50,
DD4ULXD8J50, DD4ULXD8X52.
This product meets the Essential
Requirements of all relevant European
directives and is eligible for CE marking.
Note: For transmitters operating in the V50
and V51 bands: nominal free space antenna
gain at middle of the band is typically -6 dBi,
and rolls off at the band edges an additional
-4 dB.
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation
of this device is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must accept
any interference, including interference that
may cause undesired operation of the device.
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes
: (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en
compromettre le fonctionnement.
Note: EMC conformance testing is based on
the use of supplied and recommended cable
types. The use of other cable types may
degrade EMC performance.
The CE Declaration of Conformity can be
obtained from: www.shure.com/europe/
7