Disposal - Invacare Carroll CS3 User Manual

Recommended separation distances between portable and mobile RF communications equipment and the CS Bed
The CS Bed is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The customer or the user of
the CS Bed can help prevent electromagnetic interference by maintaining a minimum distance between portable and mobile RF communications
equipment (transmitters) and the CS Bed as recommended below, according to the maximum output power of the communications equipment.
Rated maximum output power of
transmitter
W
0.01
0.1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in metres (m) can be estimated
using the equation applicable to the frequency of the transmitter, where P is the maximum output power rating of the transmitter in watts (W)
according to the transmitter manufacturer.
At 80 MHz and 800 MHz, the separation distance for the
higher frequency range applies.
These guidelines may not apply in all situations.
Electromagnetic propagation is affected by absorption and
reflection from structures, objects and people.

2.4 Disposal

This product has been supplied from an environmentally aware
manufacturer that complies with the Waste Electrical and Electronic
Equipment (WEEE) Directive 2012/19/EC.
1153410-N~00
Separation distance according to frequency of transmitter
m
150 kHz to 80 MHz
d=1.2√P
.12
.38
1.2
3.8
12
80 MHz to 800 MHz
d=1.2√P
.12
.38
1.2
3.8
12
This product may contain substances that could be harmful to the
environment if disposed of in places (landfills) that are not appropriate
according to legislation.
Please be environmentally responsible and recycle this product
through your recycling facility at its end of life.
800 MHz to 2,5 GHz
d=2.3√P
.23
.73
2.3
7.3
23
Safety
17