Table of Contents
Advertisement
Cleaning and care
Carrying out the descaling process
As soon as the intake process
has started the descaling process
can no longer be cancelled.
Select the Moisture plus function.
Use the rotary selector to
select .
Confirm with OK.
If Moisture plus was already
locked, the descaling process can be
started immediately by touching OK.
The prompt for the drawing in process
( ) will appear and the triangle will
flash under
Confirm with OK.
The intake process will begin. You can
hear the pump while this is happening.
The amount of solution specified can be
more than the amount which is actually
taken in. Some of the solution may
therefore be left in the container at the
end of descaling.
108
The activation phase ( ) will begin.
You can follow the duration as it counts
down.
Leave the container with the tube
The system will take in more liquid at
approximately 5 minute intervals. You
will hear the noise of the pump for a
moment or so.
The descaling step can be displayed:
Select .
Use the rotary selector to move
To display time remaining, use the
At the end of the activation phase a
buzzer will sound, if the buzzer is
switched on (see "Settings - ").
connected to the water intake pipe in
the oven. Top the container up with
approx. 300 ml of water, as the
system will need to draw in some
more liquid during the activation
phase.
the triangle until it lights up
under .
rotary selector to move the
triangle until it lights up
under .
h
Hide quick links:
Advertisement
Table of Contents
