Hamilton Beach HBH750 Series Operation Manual page 6

Using the Controls
P
Hold button to run blender at high speed. Release to stop blender.
JUMP
Information and Settings
PROGRAM UNIT
SELECT
SELECT OR SCROLL
INFORMATION
SELECT
SELECT OR SCROLL
For all options below, press
any option to exit program menu.
CYCLES INTO WARRANTY
SELECT
CUSTOM CYCLE COUNTER
SELECT
CLEAR CYCLE COUNTER
SELECT
CUSTOMER SERVICE
SELECT
DISPLAY BACKLIGHT
SELECT
QUIET SHIELD SENSOR
SELECT
RUN COOL DOWN CYCLE
SELECT
FACTORY DEFAULTS
SELECT
SOFTWARE VERSION
SELECT
EEPROM VERSION
SELECT
6
Hold to enter the menu and scroll up
PROGRAM UNIT
SELECT
SELECT OR SCROLL
Press to enter INFORMATION menu and scroll up
PROGRAM UNIT
SELECT
SELECT OR SCROLL
to view information or scroll for next option. Press
PROGRAM UNIT
SELECT
SELECT OR SCROLL
CYCLES INTO WARRANTY.
CUSTOM CYCLE COUNTER. This cycle counter can be reset by the operator.
CLEAR CYCLE COUNTER. This option will only clear custom cycle counter, not
cycles into warranty.
CUSTOMER SERVICE.
DISPLAY BACKLIGHT. Scroll to enable or disable option for constant display
of backlight.
QUIET SHIELD SENSOR. This can only be disabled for 120V.
RUN COOL DOWN CYCLE. If the blender motor overheats, this message will
be displayed to prompt you to run a cool-down cycle. Remove the container
from the blender and press
FACTORY DEFAULTS. This option will restore all programs to factory defaults.
SOFTWARE VERSION.
EEPROM VERSION.
to INFORMATION option.
to view below options.
. (For 230V, the Quiet Shield™ must be closed.)
PROGRAM UNIT
SELECT
SELECT OR SCROLL
a second time during
PROGRAM UNIT
SELECT
SELECT OR SCROLL