Status > Device Information; Status > Ethernet Statistics - Cisco Linksys RE1000 User Manual

Linksys RE1000
Status > Device Information
The Device Information screen displays information about
the router and its current settings
Status > Router
Device Information
Firmware Version The version number of the router's
current firmware is displayed
Firmware Verification
The unique identifier of the
firmware is displayed
Current Time The local time is displayed
Internet MAC Address The router's MAC address, as seen
from the Internet, is displayed
Device Name
The Device Name is the NetBIOS name
of the router The default is Cisco followed by the last 5
digits of the router's serial number, which is found on the
bottom of the router If you used the setup software for
installation, then the Device Name is the name of your
wireless network (up to 15 characters)
Host Name The Host Name of the router is displayed
Domain Name The Domain Name of the router is
displayed
Internet Connection
This section shows the current network information The
information varies depending on the Internet connection
type selected on the Setup > Basic Setup screen
For a DHCP connection, select Release IP Address or
Renew IP Address as appropriate to release or renew
a DHCP lease For a PPPoE or similar connection, select
Connect or Disconnect as appropriate to connect to or
disconnect from the Internet
Click Refresh to update the on-screen information
Status > Ethernet Statistics
The Ethernet Statistics screen displays information about
the local network
Wireless-N Extender
Chapter 2: Advanced Configuration
Status > Local Network
Ethernet Statistics
Ethernet port status
The Status of the Extender's local Ethernet port is
displayed
Packet Sent (TX)
The number of packets transmitted is displayed
Packets Received (RX)
The number of packets received is displayed
Packets Dropped (TX)
The number of packets dropped on the transmit direction
is displayed
Packets Dropped (RX)
The number of packets dropped on the receive direction
is displayed
Collisions
The number of collisions occurring on the wire is displayed
Errors
The number of errors is displayed
Ethernet Port Lights
Status > Ethernet Port light
On/Off
To allow the lights on the Extender's Ethernet port to light
up, keep the default, On
13