Connecting The Optional Touchscreen; Power Management System; Figure 6: Connecting The Optional Touchscreen Cable - Planar VS15XAD Operation Manual

Connecting the Optional Touchscreen

If your monitor has this optional feature, connect the monitor's 9-pin D-sub
serial port to the computer's 9-pin RS-232 serial port using the cable that came
with the touchscreen package.

Figure 6: Connecting the Optional Touchscreen Cable

Next, connect the male end of the RS-232 cable to the 9-pin serial port at the
back of the monitor (see Figure 6).
Note: Follow the instructions included on the enclosed CD for installing the
touchscreen drivers on your system. If you have questions, contact your
system provider or Planar Systems, Inc. at www.planar.com for the
touchscreen driver and installation instructions. Following driver software
installation, calibrate your touchscreen to the system following the
procedure described on the enclosed CD.

Power Management System

The Planar VS15XAD VitalScreen Medical Grade Monitor complies with the
VESA DPMS power management standard. This standard provides four power-
saving modes, based on the monitor detecting the horizontal or vertical sync
signals. The table below describes those four modes.
Mode
On With audio
Without audio
Standby
Suspend
Off
When the monitor is in power saving mode or detects incorrect timing, the
screen is blank and the power LED indicator blinks.
Operations Manual (OM705-00)
AC Input Power LED Status
(including AC
adapter)
40 watts maximum Steady green
37 watts maximum Steady green
5 watts maximum Blinking green
5 watts maximum Blinking green
5 watts maximum Off
11