Lexus 2003 SC430 Owner's Manual page 88

3. Press and release the vehicle's programmed HomeLink
button twice. The garage door may open. If the door does
open, the programming process is complete. If the door does
not open, press and release the button a third time. This third
press and release will complete the programming process by
opening the garage door.
The ceiling mounted garage door opener motor should now
R
recognize the HomeLink unit and be able to activate the
garage door up/down.
4. Repeat steps 1 through 3 for each remaining HomeLink
button to program another rolling code system.
INFORMATION
If you register a program in the HomeLink
"Rolling Code" type transmitter, the transmitter must be
reprogrammed to use it again.
R
Programming an entrance gate /
Programming all devices in the Canadian
market
1. Decide which of the 3 HomeLink
program.
2. Place your hand–held gate/device transmitter 25 to 75 mm
(1 to 3 in.) away from the surface of the HomeLink
Keep the indicator light on the HomeLink
R
programming.
3. Press and hold the selected HomeLink
4. Continuously press and release (cycle) the hand–held
gate/device transmitter button every two seconds until step 5
is complete.
R
using a
5. When the indicator light on the HomeLink
slow to a rapid flash after 20 seconds, you can release both
buttons.
6. Test the operation of the HomeLink
programmed button. Check to see if the gate/device operates
correctly.
7. Repeat steps 1 through 6 for each remaining HomeLink
button to program another device.
2003 SC430 from May '03 Prod. (OM24449U)
INTERIOR EQUIPMENT
R
buttons you want to
R
.
R
in view while
R
button.
R
changes from a
R
by pressing the newly
R
71