Table of Contents
Advertisement
Do not use with a damaged or deformed
battery.
Remove the battery whose life cycle has
expired from equipment immediately.
When a handset is set to Vibration mode,
the vibration can sometimes cause the
MD-2 handset to move.
Use a damp or anti-static cloth to clean the
handset. Do not use an ordinary dry cloth
or electrostatically charged cloth. Do not
use chemical or abrasive cleaners as these
could damage the case.
Remember to make backup copies of all
important data on your handset.
Note:
Caution risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries
according to the instructions.
Aircraft Safety
Switch off your phone when inside or near
aircraft. The use of handsets in aircraft is
illegal. It may be dangerous to the
operation of the aircraft and it may disrupt
the cellular network. Failure to observe
this instruction may lead to suspension or
denial of cellphone service to the offender,
or legal action, or both.
Hospital Safety
Switch off your phone and remove its battery in areas where the use of handsets is prohibited.
Follow the instructions given by the respective medical facility regarding the use of handsets
on their premises
Do not solder a battery directly
The earpiece may become warm during
normal use. Also, the handset itself may
become warm while the battery is being
charged.
Be careful not to place the handset near
heat sources (such as a heater) or too close
to the edge of the table.
Third party equipment: The use of third
party equipment, cables or accessories, not
made or authorized by manufacturer, may
invalidate the warranty of your cellphone
and also adversely affect the phone's
safety/operation.
Remember to recycle: the cardboard
packing supplied with this handset is ideal
for recycling.
Do not use the handset on the ground
without the permission of the ground staff
Advertisement
Table of Contents
